going to bed foam in the morning

This is a very simple design on a console. Nothing fancy.. just a lot of work. either way

Martin thanks for the pictures. Looking good so far.:D

added foam to top of console
 

Hoping to finish this week

Looks great can't wait to see it when u pop it

Some More Pictures. I added the foam and glassed with 1 layer of 1.5 oz csm for adhesion to foam. may be over kill but I never had problems with delam. added foam with some cabosil mixed with resin. then weighted down with buckets of water .let set- up ..Then one layer of 1808 0-90 and then another layer of drop scrap 1808 0-45 and 1708 0-45 .. abit frankinstien-ish as far as the glass goes. but I just have so much drop that it is getting in the way.

more pics
 

first 5 pics are the back of console.
the last four are the top of console

I know I did not show the steps or process very well. but As I said before. I always sandwich the foam in csm when installing. So that I have a good bond to the foam.. It also help that the foam has resin channels cut into it as well as weep holes drilled every 1 " square

Hopefully do a side tonight then the other one in the morning. and the seat and front sat night .. and pull out sun afternoon

Looking good. I try to use up as much scrap/drops as I can too, so I'm with u there. Can't wait to see it poped out and to hear how easily it came out the mold (I hope). Been doing a final 320 grit sand on the leaning post bait well this morning. Hope to wax tonight and maybe start glassing.