Re: Bow rail, 20 ,deep 6 or repair
 

Run a 1" tape line around the top cap outside & Inside . Then NoN-Skid it. Slight contrasting paint.Cleans it up & will stop Ya from slipping off(What the Foot/Hand rail did before.
http://www.frenzie.com/bimini%20out.JPG
Just an idea. [img]/images/graemlins/cool.gif[/img]

Re: Bow rail, 20 ,deep 6 or repair
 

Yo Tug

What kind of "VERMITS" y'al gots hanging around that SeaCraft that you need to squirt 'em with that yeller thing [img]/images/graemlins/confused.gif[/img]

http://img.photobucket.com/albums/v1...mitstopper.jpg

Hope it's not one of dem "Cooters" you be servin up on a plate of gritz http://www.clicksmilies.com/s0105/wu...smiley-011.gif

Re: Bow rail, 20 ,deep 6 or repair
 

Man! you guys get redder everyday. What the hell is the matter gritz? [img]/images/graemlins/confused.gif[/img] Ok fine grits. Is that better? [img]/images/graemlins/mad.gif[/img]

Re: Bow rail, 20 ,deep 6 or repair
 

LOOKING FOR GUNNEL MOUNT ROD HOLDER !!!!!!PLEASE HELP CHECK THE FOR SALE FORM FOR DETAILS THANKS JOE R, PS THANKS FOR THE INPUT ON THE BOW RAIL ITS OFF.

Re: Bow rail, 20 ,deep 6 or repair
 

Is this what you are talkin about:

http://www.classicseacraft.com/23intbow.JPG

if so this is the firm that makes them:

E tec Marine

Re: Bow rail, 20 ,deep 6 or repair
 

that be them.

Re: Bow rail, 20 ,deep 6 or repair
 

ContenderCraft [img]/images/graemlins/wink.gif[/img]

Re: Bow rail, 20 ,deep 6 or repair
 

Forgot the mention, that pic is courtesy of Seafari and as he mentions they are the same ones Contender uses.

Tx Rodney

Re: Bow rail, 20 ,deep 6 or repair
 

Thanks Jason,
Since we're talking recessed rails, The one I
used is 3/4 pipe, a little thicker than the
origional. With the E-tec stand offs, you can slide
them down the pipe so you can use the origional
holes. Also the cost of the E-tec parts and pipe
are only about 300.00. Its very important to bend
the new pipe exactly like the origionals!

Re: Bow rail, 20 ,deep 6 or repair
 

Thanks for the info. I've been in contact with E-tec. The fellow I spoke to said they were aluminum and the round needs 3/4 id pipe. This may not work for me since my fabricator already bought the 7/8 od tubing. I'll talk to him to see what can be done. If he can easily use the 7/8 on other stuff, I'll probably go with e-tec parts.