Re: redoing deck in 20cc
 

hey billy, i'm from that neck of the woods, went to high school at shore regional grow up in monmouth beach, sure do miss the good fishng up there, miss the stripers,hey how's donoven's reef, had alot fun there!!anyway good luck with your boat, mike,p.s my brother has a 1976 master angler in tinton falls, nj,

Re: redoing deck in 20cc
 

Muddy,
I have the same setup - raised flange molded into the deck, horizontal screws to join the console to the flange. I am removing most of the deck and building in a 6' hatch for the fuel tank, along with bolts to attach a new, narrower console.
It's a lot more work, but should be easier in the long run in terms of fairing and finish work.

Re: redoing deck in 20cc
 

Can we see some pics of the work, going to be doing mine soon would like to see pics.

Re: redoing deck in 20cc
 

just started, nothing to see yet.

Re: redoing deck in 20cc
 

Here's a thread where I redid the floor on my 20' CC.
http://www.classicseacraft.com/forum...=&sb=5&o=&vc=1

Re: redoing deck in 20cc
 

Would love to see pics also. Good luck. :D

Re: redoing deck in 20cc
 

I just downloaded the pics from the camara. I will try to post in the morning.

Re: redoing deck in 20cc
 

What thickness Penske board did you guys use? Also, what methods have been used for making the channels, does anyone agree on which is best, and how deep do you think the channels need to be? On my 72 SF, the only things resembling channels are the areas along the side where no non-skid was placed (so probably not even 1/16" depth difference).

Thanks guys!!!