Re: Thru transom scuppers conversion from thru flo
 

Wouldn't that require water to run uphill??

Re: Thru transom scuppers conversion from thru flo
 

Aside from the Criss Cross idea; when you convert from thru floor scupper to thru transom, you gain a few vertical inches as to where the scupper exits the transom - right ?

But, you still need a product like the Rabuds or similar ?

I wish I had done this when I re-did my transom, but I had so much work on my plate, I let it go. Is it a be'atch of a job when all is together ? Again, I have a 23' Tsunami w/ an I/O - it's a little different.

There just is nothing good about the thru floor scuppers; it's to small to drain water quickly, it keeps the floor wet when weight is in the corner, and the brass tubes need replacing very so often.

I want 'em gone. But, only if it is a benefit to do so. Has anyone done a 23' ?

Re: Thru transom scuppers conversion from thru flo
 

Use plastic drain tubes instead of metallic until you have time to convert. The plastic ones are available at Discount Marine. Most Seacrafts sold after 1976 used the plastic types.

Re: Thru transom scuppers conversion from thru flo
 

abl1111,

The main reason I converted the scuppers on my project was that, as they were, they represented two uncontrolled holes through the bottom of the hull. I moore the boat and to my way of thinking, eliminating that potential disaster was a major benefit. I also plugged the fish box drain for the same reason, although the situation there is not as critical.

Regarding the crossing scupper drain piping, the lines are usually not laid flat or parallel to the water line; they slope down and generally back, often at a pretty steep angle (30^+/-).