Classic SeaCraft Community - Rod holders on port & starboard fo 1970 seacraft

Page 2 of 2

Show 40 post(s) from this thread on one page

Classic SeaCraft Community (http://www.classicseacraft.com/community/index.php)

- Repairs/Mods. (http://www.classicseacraft.com/community/forumdisplay.php?f=6)

- - Rod holders on port & starboard fo 1970 seacraft (http://www.classicseacraft.com/community/showthread.php?t=21031)

Islandtrader

07-12-2010 10:19 AM

Re: securing bow rail

Over drill the holes and then fill with epoxy. When dry tap in some new holes and you should be done.

abl1111

07-12-2010 10:45 AM

Re: securing bow rail

Island Trader is 100% on the $.

However, I suspect that if the screws pulled out that you have some water damage and that has to be removed.

I had some water damage with mine and I removed it from below, glassed in some balsa with NO balsa near rail mounts ( just a lot of extra glass mat in that area and it's perfect )... Only PITA is the rail mounts forward of the bulkhead ( I have a 23' Tsunami ).

I don't remember if thru bolts were OEM - but I thru-bolted mine.

Good luck.

All times are GMT -4. The time now is 05:44 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page