[QUOTE=martin;239272]Rule 13,523....do not throw away parts to be replaced...took mese time to just make a pattern for front anchor locker...BTW this is the rule right after the one. About make sure you have all bulkheads in before glueing down Cap!!! Smdh[/QUOTE
Pic
]

[QUOTE=martin;239273]

Layed up one side of the forward anchor bulkhead hatch.used the outside patio table as my layup table.. Layed some visqune down. Cut the 1708 and wet out, then wet one side of the foam. Set it and forget it. Well not until I layed another layer on top of foam and added weight to pull the excess resin to the top.....

Anchor bulkhead
 

Layup

Paint
 

I hope to have her painted by December...

I cannot wait for the Temps to warm abit.. although sanding in 40 degree weather is like sanding in an air conditioned tyvex.... I am getting the itch again..

Well it is finally getting the tic it needs.. I sent my boat to the most eperienced fiberglass boat builder in Panama City..Mattke Brothers I know will do a fine job...

Forward progress
 

Well it has been five days now and Steve Matkke has been making some forward progress. I made a list of things I wanted done, most of it being custom work...so far I am very please with the results and most of all the communications we keep with each other during the build process..mind you I hired him do just fiberglass work and some fairing. As I will do the final fair,prime and paint...

Pics
 

pics

Rubrail and vents
 

Pics