Just make sure that you cover every place the Arjay can come out from. It sucks to find a small screw hole or something else as your pouring.

Ditto.

Does anyone have a 20" motor on a bracket? will this even work?

have been working on the boat past 2 weekends. got the transom poured with arjay and have started re-coring the cap with 1/2" NidaCore. trying to upload pics but my photobucket wont let me share 3rd party. anyone have a good service for sharing pics

Looking good. Just like my transom

Has anyone added bow seats/storage to a 20 MA? Raise up the forward deck making a deeper fishbox/cooler. Something like this

Since it has been too cold or rainy to work on my cap I have been puttering around with a mold for my baitwell. It will be a drop in under the console seat. Here is a pic of the mold. Here are my thoughts on a layup. Gelcoat then 3/4 oz mat then "tape" all the seams with 1708 4" wide then a 2-3 layers of 1708. Built up to 3/16" thick. I will then tab some gussetss inside the console to support the walls and bottom. Tabbing it around the lip of the original console seat.

I will post some pictures later but I have finished the cap and reinstalled it., and cut out the floor. Floor was only connected to the boat at the splashwell and front locker. All potter putty had let loose on the stringers.my question is what to use for the new floor? I was thinking 3/4 marine ply and epoxy with 1708 1 layer on bottom 2 on top. Thoughts?

Go with nida core it never rots weighs less and you never have to do it again. Just put something stronger where the console and other things are nailed down