Re: Emblem-CNC UPDATE!!!!!!!
 

Carla,

Great job. As I was told many times, my check is in the mail.

Peter

Re: Emblem-CNC UPDATE!!!!!!!
 

Carla

My check is going out on Monday! The Dink

Re: Emblem-CNC UPDATE!!!!!!!
 

I sent the check sometime lastweek, if you don't get it very soon I have a paypal account if you can do it that way its not a problem for me to transfer money that way.

Re: Emblem-CNC Drawing!
 

Carla,
Please sign me up for two, nice job by the way.
Checks in the mail on 3/20/07.
Thanks,

Re: Emblem-CNC Drawing!
 

Carla,
I am extremly late in the game here but would like a pair if you can squeeze them in to the order.
If not, my loss ,they look great and would definatly set our boats out from the crowd of later SeaCrafts.
Let me know and a check is on the Way.
Donnie

Re: Emblem-CNC UPDATE!!!!!!!
 

Carla,

Thanks for your efforts.

Re: Emblem-CNC Drawing!
 

Here's the status:

I asked Brian (SS Fabrication Shop) to run the full sheet, yielding approx 135 emblems. I have orders for 128 (not including NotWorking & SCSeacraft). That leaves 7 on reserve to insure none are lost in the mail. I'm optimistic everyone will get their's.

After they are all received in the mail, then I'll be glad to mail out the remainder for those who wish to join in the order. On the list so far is NotWorking & SCSeacraft. (NotWorking...I will hold your check until that happens).

The emblems should be ready for pickup anyday now & the packages are already addressed & ready to be shipped as soon as I get them.

I have not received checks for 8 orders, & will be sending out PM's to those people. Hopefully none of those have been lost in the mail.

This project has been a tremendous success with so much support from everyone. Thank you so much!
Carla

Re: Emblem-CNC Drawing!
 

Thanks again for your efforts and I am looking forward to putting them on the boat.

But first I will need to figure out how to remove my old film emblem with out messing up my paint job??? Some one need’s to post the how too’s on that.

Oh buy the way if you ever decide to make a run of Seacraft emblemed Golden Beer Can Holders count me in. I bet you would probably get 3 times the takers on that one.

FellowShip

_______________________________________________

My motto: Just for the Grins :D :D

Re: Emblem-CNC Drawing!
 

Strap that new heater on and make a couple of passes on med degrees and a plastic putty knife should do the trick [img]/forum/images/graemlins/tongue.gif[/img]

Re: Emblem-CNC Drawing!
 

Thanks Chuck

FellowShip

_______________________________________________

My motto: Just for the Grins :D