Think about Gemlux Scuppers. They have replaceable flappers. The ping-pong balls within the Rabuds are very noisy at rest or drift fishing. Just some thoughts

They make beautiful stuff for sure. I think I painted myself into a corner with the design. The gutters drain to the splashwell and the scuppers exit the transom tight in the corners. Picture doesn’t really show inside of transom. Would love to justify some more of their jewelry but I don’t have anything to attach on barb end. I think only choice is exterior style. Don’t remember them annoying me but I hear you....and now I will notice.

I put some of these on my 20 Bertram and they worked ok.
https://www.amazon.com/TH-Marine-Scu...PPSWYQ8JWX1797

I think those are worth a try. Appreciate the review.

And where are pics of this Bertram? I love those boats!

I might have a couple somewhere but the ex got most of the photo albums. It was an original '65 Moppie 20 (Hull #223) -still had the curved glass windshield. Repowered with a 290HP small block and a Volvo 290 drive. Guy I sold it to took it to Eleuthera about a month before Andrew leveled the island - guess it's a reef now.

One last ride before putting it away for the winter. GPS is connected and I found minimum planing speed to be 13-14 mph. Still haven’t been able to verify max numbers but saw 46 with more room to go. I know the first number is more important but I’m pretty happy all around. I’m not getting all the engine info on the Garmin 742. If any of the ETEC guys have setup advice, it would be appreciated.

Which info isnt showing up?

I’m getting RPM, fuel flow, miles, volts. Need to set max RPM and I read you need a resistor if you use an analog trim gage at the same time. No oil pressure, trim, etc. Probably can’t zoom the picture very well.

Etecs don't have oil pressure :)