Classic SeaCraft Community - For Sale: Johnson 200 Ocean Runner & Bracket

The single engine Stainless Marine bracket is brand new, powder coated white (includes SM's Logo),
and measures 16" wide with a 30" set-back (allows full out of the water tilt for the motor). It comes in three parts, the engine bracket center section and two (L & R ) swim step 'wings' which may be added to either side,one side, or not at all. All mounting hardware is included.

Flotation is very good, and the center section alone certainly weighs much less than the full beam alternatives.The price for all three pieces is $985.00 I'll try the PIX tomorrow.

The '93 Johnson 200 was winterized in February of 2001 and has been stored in my office ever since.
It previously had one owner, and approximately 217 hours. I will set-up and run the engine for a
seriously interersted party. The price for the engine package is $3,550.

The engine package includes the following brand new accessories:
OMC side mount throttle/shift, key start switch, instruments,wiring harness, oil tank and (refurbed) ss Prop.

If sold as a package, the bracket and engine would be $4,215.00, Fort Lauderdale.

I also have many other new parts such as NEW hydraulic steering, battery charger, etc.

These items were collected to complete the project
23' 1993 Tsunami which I advertised on this site on
April 15th. (Perhaps a 'downer day' to advertise anything?)

You can call me in Ft Lauderdale at 954-859-8458.

Hate to see these items go, but no space to finish the 23' Tsunami project any time soon.