My 20 SeaCraft after 6 months work
 

Lets see if I can figure out how to put the pictures up!

Re: My 20 SeaCraft after 6 months work
 

http://i151.photobucket.com/albums/s...7/CIMG2237.jpg
http://i151.photobucket.com/albums/s...7/CIMG2238.jpg
http://i151.photobucket.com/albums/s...7/CIMG2235.jpg
http://i151.photobucket.com/albums/s...7/CIMG2252.jpg
http://i151.photobucket.com/albums/s...7/CIMG2242.jpg

Re: My 20 SeaCraft after 6 months work
 

The boat got a new 25 inch transome with extra gussets for support, a new fiberglass leaning post made by me out of a formica mold custome, I raised the console to be able to mount new chartplotters, new 60 gal tank , new 15 gal freshwater wash down,the front compartment on the console (seat) was turned into a cooler with 2 inch foam sheets,new Awlgrip inside out including in the hatches, new rub rail,basicaly all new except an old 1973 Seacraft and a 2001 trailer , and if you dont know its a pain in the !!! to put pictures up on the forum. I hope my pictures and ideas will inspire someone else to restore a Seacraft. Jose

Re: My 20 SeaCraft after 6 months work
 

Forgot, Im also haveing new light gray channel cushions made with a black welp around them for console backrest & seat leaning post and two seats by the engine if I ever find an engine at the right price, Thanks again for looking at my junk. Jose

Re: My 20 SeaCraft after 6 months work
 

Nice, looks like quite a productive six months. With that high console you will definitely be able to dodge any spray while flying through rough seas!! :cool: What power are you planning for her?

Re: My 20 SeaCraft after 6 months work
 

Its a split decision between merc. or yamaha 225 or 250 hp no less, not that i need to race its the fuel economy you get from big displacement outboards on little boats, I run engines about 3500 - 4000 rpms and I want a 40 mph cruise

Re: My 20 SeaCraft after 6 months work
 

in that case I hope you raised the height of the original floor a good bit.

Re: My 20 SeaCraft after 6 months work
 

BTW, let us know if you'd recommend your cushion fabricator(presuming they're local). The wife is threatening boycott if the comfort factor does not improve soon! :eek:

Thanks!

Re: My 20 SeaCraft after 6 months work
 

Can you say rocketship? Better get Yeager to test pilot that one. :D

Nice boat, looks sharp. Interesting console.

Re: My 20 SeaCraft after 6 months work
 

glassman,
I have 225 EFI Merc 20" shaft on my 73 20' and it is far more than enough. In cool weather and good water im at 69 mph with 2 guys and 3/4 full fuel. Word to the wise it will start to walk on it chines, be careful. But you can win some races that is for sure!!