Classic SeaCraft Community

Classic SeaCraft Community (http://www.classicseacraft.com/community/index.php)
-   Repairs/Mods. (http://www.classicseacraft.com/community/forumdisplay.php?f=6)
-   -   20 MA/ Bracket/ 20 inch Shaft (http://www.classicseacraft.com/community/showthread.php?t=20002)

Michael Vezzosi 02-09-2009 07:07 PM
20 MA/ Bracket/ 20 inch Shaft
 
I am considering bringing my 1979 20 MA (without raised floor or trim tabs) down to Hermco for a transom enclosure, livewell and bracket. Is it not possible to use a 20" shaft (1999 Johnson 175, with 140 original hours) for this application? I do not want to repower, but if this is just not possible, I need to know sooner than later.

If true, then I will be selling a 2008 Yamaha F60 NIC, and mounting the V-6 175, and hydarulic jack plate to my 1988 Boston Whaler Sport 15. I know that this may sound NUTS but there is a method to my madness. Any thoughts appreciated. Thanks. Part II.

Old'sCool 02-09-2009 08:14 PM
Re: 20 MA/ Bracket/ 20 inch Shaft
 
You're close enough to let me drive the 15 w/175 :D

McGillicuddy 02-09-2009 08:35 PM
Re: 20 MA/ Bracket/ 20 inch Shaft
 
Don't know the answer but here's a $500-600 "plan B" in the case 25" is required on the bracket:

http://www.baymfg.com/Bombardier.asp

Sure wish I could take my rig to Hermco.


All times are GMT -4. The time now is 04:48 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft