center console
 

The screws on the port side of the center console securing the console to the deck are stripped out.The deck seems sound in that area.Does any one have any suggestions about the best way to go about repairing this.

Re: center console
 

Get some six 10 and fill the holes...and after its dry re-drill.

Six 10

Re: center console
 

Island Trader

Would you say that this six-ten is good for patching old holes in the transom from previous transducer mounts, etc? I see a lot of 5200 being used there. This sounds like a more permanent fix.

Re: center console
 

where can i find this product 6 -10 i did an internet search and could not find it or any info. about it.

Re: center console
 

Check the link in Island Traders response above.

Re: center console
 

Yep! It is a neat product...a little pricey for big jobs, but the stuff does work. I try not to use the static tool unless I need to lay down a nice fillet or long run.

Most West Marine stores have it...Or James Town Distributors.

Re: center console
 

Terry,
Do you have to clean the static tool after each use to keep it from plugging with set up epoxy?
Dave

Re: center console
 

Blue from what I read...yes, you have to clean it out or they sell additional static tips, so you can just replace the tips.

Re: center console
 

I have not tried to clean the tips...if anyone has a suggestion on how please post.


The extra tips are couple of bucks each.