Classic SeaCraft Community

Classic SeaCraft Community (http://www.classicseacraft.com/community/index.php)
-   Performance (http://www.classicseacraft.com/community/forumdisplay.php?f=5)
-   -   PERFORMANCE (http://www.classicseacraft.com/community/showthread.php?t=22125)

FINNERTY 11-04-2010 03:32 PM
PERFORMANCE
 
What is the correct length for a replacement outboard motor on a 1985 23'
Superfisherman Center Console?

McGillicuddy 11-04-2010 03:42 PM
Re: PERFORMANCE
 
If originally a single, it was probably cut for 25". If it was cut for twins and you want to run a single, you'll need a 30" shaft. Take a measurement to be sure. Measure along the transom from the top center of the transom cutaway down to the bottom of the keel. The result + or - an inch will be your answer.

FINNERTY 11-04-2010 03:48 PM
Re: PERFORMANCE
 
Thanks for the education.

castalot 11-04-2010 06:11 PM
Re: PERFORMANCE
 
Quote:
If originally a single, it was probably cut for 25". If it was cut for twins and you want to run a single, you'll need a 30" shaft. Take a measurement to be sure. Measure along the transom from the top center of the transom cutaway down to the bottom of the keel. The result + or - an inch will be your answer.
perfect answer
i have twin 25" motors
center of splash well to bottom is 30" so i would need a 30"single they did have a 25" transome so measure it


All times are GMT -4. The time now is 07:10 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft