Thru hull fittings / Scuppers
 

I had some spare time yesterday and began the removal process of the plastic thru hull deck drains on my 23' SeaCraft yesterday. They are not comming out to easily. I was hoping to remove them in one piece to ask you guys what you recomend replacing them with but thats not going to happen. Anyhow, what have you guys used to replace the plastic thru hulls. I saw the moeller drain tubes but I'm not really sure they are meant for that application? Also looked at the Groco thru hulls and did not see anything that looks like what I am removing? If there is any visible light left when I get home I will take some picture to show you what I'm working with. I had one boat sink because of a failed thru hull and I won't let it happen again.

Re: Thru hull fittings / Scuppers
 

I replaced all mine with Gem Products hardware. It is all stainless and reasonable. Let me know if you find something on their site you like, I will give you a quote.
S. Todd Tharp
CFHRC President
Todd's Rigs & Lures
Montverde, FL 34756
407-469-2396, office/fax
321-377-3464, mobile
trr1rigs@att.net, e-mail
www.toddslures.com
www.lubedealer.com/toddslures

Re: Thru hull fittings / Scuppers
 

I'll go with Gemlux too.

Re: Thru hull fittings / Scuppers
 

Thats what I was looking for..almost sank mine last summer when the vinyl fitting cracked, bad feeling having water on the floor 24 miles from the ramp. Its one I don't care to ever have again. Thanks!