starting my 1972 20' seacfrat
 

i am starting my first seacraft. I have no experience and am planning to tackel most myselfe. Mainly prep work. I will have pictures soon and am open for advice.

"Another one bites the dust, another one bites the dust"

Ahhhh.....the SeaCraft addiction has hooked another one!! Good luck!!!

thank you, i need all i can get.

the cobia are starting to show up and is slowing down my project

here are some pics

not sure how to free gunnel cap from transom. is it okay to cut it??

here are some more pictures

i'm thinking of cutting the remaining 2 inches of floor and install the new floor before i put gunnel cap back on, then 5200 the gunnel cap to floor

to remove the gunnel cap i was thinking of bolting 2 by 4s across the gunnel and using a come along to lift it up, but am still scratching my head on how to free it at the transom and where the rear boxes are glued to transom. was thinking of taking my dremel and cuttin along the corner where it is blued to transom. is that ok?

You should plan on several days of reading the repair section here. Lots of good stuff