1968 Seacraft Seafarer seat to hull brackets
 

I bought a 16 Seacraft Seafarer with a Johnson 28SPL engine that has been sitting outside for a number of years.

I cleaned it up and rebuilt the carburetor and have been pleased with the boat.

It looks a little rough, but no leaks and starts every time and gives me a good inexpensive platform to go fishing from.

The problem I have is the front seat brackets are broken.


Does anyone know a vendor or have had these fabricated before I start this “small” project?

http://i74.photobucket.com/albums/i2...1/IMG_1504.jpg

SeaCraft made a 20' hull in CC, Sceptre runabout and Seafari cuddy cabin models, and a 19' Bowrider, an 18' CC model, and a very rare 15' Scampi runabout model, but they never made a 16' model, so I doubt you have a SeaCraft unless quoted length is wrong. I've also never seen a seat bracket like the one shown . . . they always used pedestal seats. Post a shot of the transom showing the 3 different VDH panels on each side of the hull if you want to confirm it's a SeaCraft.