Few things done
 

Glassing transom crown and bulkhead putting a reveal around it to match cap for rub rail

Got my front anchor hatch in and I have 2 vents that will be up under the cap overhang so u won’t see them. Getting some primer on

I dont see any empty beers in that sunset shot...

Trust me they are there

Nice work!

Very nice work. I just spent a ton of time, and forking cash on an anchor hatch, trapezoid, only to find that the locker does not have enough depth to set the shank down vertically on my 20 MA. Live and learn. Sure looks useful. What a waste.

Keep it up! Looking good!

Vezo, Part II

Can you customize the anchor to fit. Little cutting and welding.

I had anticipated a PVC pipe, mounted vertically, with slots at the top to accept the anchor shaft. Pretty sure I do not want to mess with my anchors design as much as I use it in the Gulf. Just trying to help others, with 20’s, that there is just not that much room from top of bow, to bow eye. Didn’t realize it before ordering the hatch, and the hole was cut. Foolish and expensive mistake.

Part II

That’s to bad it won’t work. I finish up my cap yesterday we are going to put back up on boat this afternoon. Going on stands this week so I can grind sand and prep from the spray rails down bottom and then it will be Ready for paint.

Drilling holes