Forum: Repairs/Mods.
04-18-2012, 10:06 PM
|
|
Replies: 24
Views: 1,426
|
|
Forum: Repairs/Mods.
04-18-2012, 10:04 PM
|
|
Replies: 24
Views: 1,426
|
|
Forum: Repairs/Mods.
04-10-2012, 08:25 PM
|
|
Replies: 2
Views: 234
|
|
Forum: For Sale
03-27-2012, 01:20 PM
|
|
Replies: 19
Views: 1,706
|
|
Forum: SeaCraft Photos
03-27-2012, 06:46 AM
|
|
Replies: 9
Views: 913
|
|
Forum: SeaCraft Photos
03-26-2012, 07:54 PM
|
|
Replies: 9
Views: 913
One small soft spot repair turned into all new...
One small soft spot repair turned into all new coring on the starboard side,center panel and port side under the console (everything was soaked). Console was lifted floors repaired then reattatched...
|
|
Forum: Performance
03-26-2012, 06:17 PM
|
|
Replies: 10
Views: 1,249
|
|
Forum: SeaCraft Photos
03-24-2012, 07:03 PM
|
|
Replies: 9
Views: 913
|
|
Forum: SeaCraft Photos
03-22-2012, 08:34 PM
|
|
Replies: 44
Views: 5,659
|
|
Forum: Performance
03-21-2012, 10:39 PM
|
|
Replies: 10
Views: 1,249
|
|
Forum: Performance
03-19-2012, 07:10 PM
|
|
Replies: 10
Views: 1,249
motor is not on a bracket boat still has the...
motor is not on a bracket boat still has the original transom. A 17 wouild rev a little higher for sure I started with a 17 pitch should have kept it on there, seemed a little to touchy at the time.
|
|
Forum: General
03-18-2012, 08:09 PM
|
|
Replies: 35
Views: 3,345
|
|
Forum: General
03-18-2012, 10:00 AM
|
|
Replies: 35
Views: 3,345
|
|
Forum: Performance
03-16-2012, 07:54 PM
|
|
Replies: 10
Views: 1,249
23CC Performance
I am Running a Yamaha 250hp fourstroke with a 19 pitch prop on my 1985 23 CC @ 5500 RPM WOT fullt trimmed out my top end is 40 MPH at cruise 4000 RPM boat runs @30 mph. Boat could use a soda...
|
|
Forum: Repairs/Mods.
03-16-2012, 07:22 PM
|
|
Replies: 5
Views: 320
How often do you raise the console? Could you...
How often do you raise the console? Could you attach aluminium angle on the inside of bottom section and thread the angle and then through bolt it to secure top section of the console better. Then...
|
|
Forum: Repairs/Mods.
03-13-2012, 09:10 PM
|
|
Replies: 9
Views: 478
Pull the tank. use a wood saw to cut the foam...
Pull the tank. use a wood saw to cut the foam along the edge. Make up a couple of angle iron pieces to slip under the tank and use a "come a long" to pick it up ,then pull it right out the back using...
|
