View Single Post
  #2  
Old 02-27-2003, 09:25 AM
Trayder Trayder is offline
Velvet Jones
 
Join Date: Feb 2002
Location: Newport RI / Key West FL
Posts: 1,642
Default Re: Transom question

Fabricate a new section to raise it the five inches. Grind away the glass on the existing transom to form an area for the new glass to hold. Place your fabricated section into the notch of the transom and glass it in place. Refinish as necessary or fabricate an aluminum or stainless brace that would encapsulate the new addition, it would wrap around the transom, and spread the load out onto the existing transom.

I am sure there are other ways but this was the first that came to mind
Reply With Quote