View Single Post
  #7  
Old 03-18-2004, 10:24 PM
thedink9 thedink9 is offline
Senior Member
 
Join Date: Feb 2004
Location: Shinnecock, Long Island
Posts: 315
Default Re: Adding floor support

Strick

After looking over your floor support fabrication job I began to wonder how I could apply this technique into repairing / replacing the soft inboard stringer on my 23. One thought I had was to cut the top of the glass off, remove the wet foam material,dry it out well , refoam and recover. If the glass is still solid do you see any reason to totally replace the entire stringer?
Reply With Quote