[elpez]

Had the same problem on my 20 cc, the console is very large for this boat, removed all the screws and sanded the bottom of the console to 2.5" above the deck, then built it up with layers of cloth amd matt fiberglass, taped the deck so as not to glass to the deck, sanded this a bit and installed a base of 1/4" starboard pplastic and a 1" lip at the base, re-drilled the screws in new positions with 5200 and its held great for over 9years, if you are ambitious, you can install an alum angle inside the console, similar to the newer seacrafts , this will give you a "new" area for the screws to grab on to. Good luck!!