Re: Deck cap and liner holes - suggestions for filling
I used oblong type pieces of fiberglass sheeting then drilled a small hole in the middle of the oblong piece tied a piece of mono through the little hole then put thickened epoxy around it pushed it through the hole pulled tight and then tied off the mono to hold tight until dried. That gave me the backing you were asking about. This will only work ware there is no lamination most of the cap has a cored end grain balsa lamination. On the small holes just open it us like a V and just thickened epoxy should do it.
FellowShip [img]/images/graemlins/wink.gif[/img]
|