[warthog5]

A couple of observation's after the fact.

The bracket should have been mocked up dry and then taped around with a 1/4in space between the bracket and tape on the transom and then the same on the bracket with a 3/16 to 1/4in space from the mounting surface. After the bracket was bolted up, use you finger to make a clean fillet of the 5200. Then the tape is peeled off to have a clean line.

The 5200 should have been Black.

The 5200 should have been applied all the way around all the bolt hole's too.



Just suggestion's for the future.