Quote:
I noticed in the shots where you had it on the boat that the stern edge mold board was against the transom.....so you did allow for that in the spacing to the front of the cap so you can slide it back the thickness of the glass???
|
Thats correct. I will cut the excess away and lign up the rear edge (13 degree angle) with the outer skin just set forward of it so I can get a couple layers of glass on it. I will glass the inside first like in the pic below. After that dries I will glass the outside. There will be a fair ammount of sanding and fairing to get it looking right.
In the end I hope to get it to look something like this. I like a nice sexy ass on my boats...always been an ass man....just cant help it
strick