Re: Bracket plans.
I'd have to go and measure it again. The numbers I remember off hand are 17"H for the front face, 23"H for the back face, 13degree transom angle, 20" on each side of the bottom deadrise. Width is either 36" or 38" at the bottom, and 38" or 40 at the widest point, and then tapered back in at the top to 36" (not 100% sure). 26" is the distance from the front face that mounts the boat to the back face of the bracket. Platform width is 72" x 24" . . . I think we angled the platform in about 3" and rounded the edges with the inside or outside of a roll of blue 3m masking tape.
There is a real tricky measurement that strick walked me through with the cap. Make sure you account for the thickness of the glass on the tapered sides of where the motor mounts.
|