Thread
:
Here We Go Again
View Single Post
#
324
08-07-2007, 05:02 PM
strick
Senior Member
Join Date: Aug 2003
Location: California
Posts: 2,738
Re: Here We Go Again
Thanks Brian. Rhett, the server was down for about 24 hours and I don't know why but I guess they got it figured out.
Still trying to get power to the shop. My friend loaned me his trencher a couple weeks ago. There are two long runs with a junction box connecting the two. The first run starts at the corner of the fence closest the house were I have a junction box that feeds power to the irrigation control system.
It makes a hard right and beelines for the opposite side of the property to another junction box.
From there it turns strait for the shop
The wire is gonna cost a small fortune just to get to the shop.
Now for the boat:
More fairing and block sanding. Another coat of Awlgrip 545 and guide coat applied;
The bottom is getting closer to paint
Another block sanding and washed off with water. At this point it seems like Never Never Land
The glorious day finally arrived when I got to shoot a little primer on the inside of the hull
There are lots of little pinholes in the panels. I think we may have got a little too aggressive in our earlier sanding and sanded thru the primer in a few spots.
Never fear. We have System 3 Quick fair.
I should have primed the transom cap when I made the part because that baby was loaded with pin holes
Stay tuned for next weeks episode entitled "More fairing and sanding"
strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
strick
View Public Profile
Send a private message to strick
Find all posts by strick