After two years on this boat things are starting to get good. We've added a teak trim strip to the lower border of the inside of the cap.
Clamps removed.
Forward over the anchor locker.
Console work. Initial fabrication of the steering pod.
Pod trial fit on the teak top of the console.
The top of the console is in three pieces: the forward portion will receive the forward supports of the T top; the middle portion will "roll up" to reveal the electronics dash; and the after portion contains the steering pod, throttle/shift and the rear supports of the top. I'm trying to decide whether to epoxy the pod in place, or just leave the duct tape.
