The past couple of days I have cleaned up all the foam so I could see what I was dealing with. Had a buddy come by to help point me in the right direction. I believe I am going to cut out what seems to be the rolls of glass, seen in pic, and put in some ribs, from the hull to the stringer and eventually to the new floor. Putting in some 45 in the corners for water drainage. Then, thinking of putting some glassed in 2x4's cross ways, every 2 feet, to tie the new floor to. Fill in holes with new foam where I dug it out. Plan on keeping the baitwell setup and putting smaller lid on and filling in holes. Put some news rigging tubes in and start sanding this thing top to bottom, bottom paint also. Any suggestions or comments are appreciated... Maybe by April it will be done....
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]