View Single Post
  #15  
Old 11-26-2008, 09:46 AM
ripndip ripndip is offline
Member
 
Join Date: Jul 2007
Location: North Palm Beach, FL
Posts: 33
Default Re: 23' CC trim tab selection

Hello,
After careful consideration and lots of research on several forums, I pulled the trigger on 12x16 Heavy Duty Lencos and installed them this weekend in place of the 12x12 Bennetts. These new tabs have a backing plate that goes up the transom and an adjustable feature where the actuator meets the plane (you can choose different mounting holes depending on the angle of the transom). I also went with the indicator switch from Lenco. I seatrialed the boat in 4-6' seas on Sunday with a full in-floor baitwell, full fuel, oil, and fresh water and THESE are the tabs for my boat. I went conservative on the initial adjustment leaving the trailing edge about 2 1/2" up from the straight edge from the bottom. At 3000 rpm/approx 28-30 mph the tab wasn't even touching the water, so I will adjust them down (just pull the bolt and go to the next hole) to the next notch giving me more usable range. The positives of these tabs versus the 12x12's are I can stay on plane at slower speeds, and the props don't blow out in heavy seas (going slow) coming off the back of one large wave and going up the face of the next.
Bennett makes a quality product, and I don't know of any company in any industry with their level of customer service. My only Bennett option was a 12x16 tab with dual cylinders= more plumbing, more stuff, slower tabs. Also, my Bennett 12x12's were barely 12x12 when measured and had some slight bending as I don't think they were strong enough for this application. The 12x16 Lencos I chose are closer to 17" on the one edge, and are thicker gauge with beefed up channels and a backing plate. They are comparable in price to the 12x16 Bennetts, but have a single actuator. After all my research, and based on how much I use the boat, I think it is inevitable I will end up replacing one or both of these (Lenco) actuators within the next 2-3 years. To me it was worth it for the speed at which they actuate, the bigger size, the appearance (electro-polished stainless with zincs; flush, sealed water proof switch with LEDs) and the no-mess/less stuff in my console.
I have over-tabbed the last three boats I have owned- a 20' Seacraft- 12x12 Bennett, a 28' Bertram 12x42 Bennett, and now this boat with nothing but positive results. That 20' Seacraft would go through anything at 16-17mph with those tabs burning no fuel and not touching the throttles- just stay behind the izonglass! I will try to post pictures soon if I can find the time.

Skyler
__________________
"Hooper drives the boat chief."
Reply With Quote