As the post "
27 Project " in the General section was getting a bit long. I decided to start a new thread in Repairs..
Now have all bulk heads above deck removed.
The termites were gettin' a little P/O'd
that we were removing their food source.
As the wood was cut out it went straight to the
burn barrel! You could hear the "snap crackle and pop"
You will notice the inner liner on the port side has
been popped loose. Plain old 2 in. chissel and 3 lb.
hammer breaks it away.
There are 3 seperate inner liners.
The bulk heads below deck were only glassed about 4 inches
to hold them in place. The rest of the exposed wood was painted.
The vintage Marinaire cover was removed and thousands
of mud dobber nests fell out!!!! [img]/forum/images/graemlins/tongue.gif[/img]
After a hose cleaning, oil motors and general once
over decided to power it up..
It ran like a charm! COLD, COLD, COLD...
Keep in mind this rascal has not run in 28 years!
Not sure if this was factory as it does not show
on
Moesly SeaCraft site as an option. It was installed
professionally though.
It's a keeper.
More later...
Ken