Well the better half finally pulled a Trump Card.
No more Seacraft work until I do some house maintenance.
So last week end when the heat index was 105 I was hanging lattice on the under part of the house (no tears from the wife, she said I would be sanding on the boat in the same heat) [img]/forum/images/graemlins/tongue.gif[/img]
However I did manage to get all the fairing done on the top side. Let me tell you sanding epoxy filler is not the same as sanding primer.
The sad part is I will be shooting sanding primer in the next few weeks and will have to do it all over again.
But hey we are having fun RIGHT!
Lattice Job. First Level is 15' Above Ground
Front Deck...All dark spots are the high areas that have been sanded down.
Transom
Port Side
Starboard side. If you look real close you will see some shiny spots. These are the low areas, that should fill in with the sanding primer.
Tools of the Trade
I know these pictures are not earth shattering, but some one got to see them
