Quote:
Plan on using plywood for the floor because it will hold screws for the t-top. how does pro-line secure tops ??
|
I am using penske board for my whole rebuild. When I put my floor in I am going to go ahead and figure where my ttop and leaning post is going to be mounted. I am going to glass some 1/4" fiberglass panel to the bottom side of floor. The panels will probably be 8"x8" and this will have plenty of strength. I have also seen people glass aluminum pads under the floor and then they drill and tap where the screws are and use stainless bolts instead. Either way it works very good along with a bit of 5200.
Adam