I don't have a seacraft. I hope I am not stepping on anyone's toes posting a non seacraft project but after reading this forum and classic mako I felt like these were the only two places I could find the information I needed without a bunch of crap that you run into on the bigger forums. For some reason my registration won't go through over at classic mako.
This sea chest will be mounted in the bilge and plumbed. The water will be supplied by two 1" thru hulls with high speed pickups. Larger sportfish's sometimes have a setup similar to this built into the hull and it is open on the bottom with a large grate over it.
Do ya'll think the laminate will be strong enough with the four layers of 1708 and and two layers of 1.5oz mat? My calculations show the final thickness will be about just over a quarter inch plus gelcoat (0.266")
|