Thank You Gents, Much to consider, especially the trim range/Angle.
Yes the Yamaha 350 might, but its allot heavier.
I was just going to experiment with this for the purpose of running a single.
If I can't get decent performance Ill probably go with twin etec 175 or twin 200 etec.
It's nothing for me to unblolt, do some composite work, and re-bracket , childsplay!!
Quote:
Originally Posted by 77SceptreOB
I'll would think the operating angle of the engine would not work at the angle the bracket appears to be in the second photo. I don't think the trim portion would go that far and compensate for that angle. Probably be up into the "tilt" area, which would be unsafe to operate at speeds above 5 mph.
I'll bet a Yamaha 350hp V8 would do the job fine...
|