Quote:
Originally Posted by Calibogue
Your lenco actuators mounted through the bracket!
I will need to do the same for them to fit and get the bracket height correct.
How much rise did you use per inch of setback?
|
For every 12" of setback, I raised the engine an 1", or should have.
I am happy with the bracket height, it is down low enough that I get a good portion of the flotation values, I can still mount lights, thru hulls, etc, thru the main hull and it is a good height for boarding.
But I feel the engine could go higher, so I will raise it a notch.
How is your project progressing?
I thank everyone for their kind comments.
It appears as if the wind Gods may have changed their minds, the first forecast for this w/e was ESE 15-20knts, little too sporty for my taste in this boat. Now that has been revised to 11-14knts, if that is the case, I'm ouuta here!!
Final touches going on, TUUCI Top, etc.
Last is the cooler, spear, rods, fins and TM/LLL II. :-)