I have used their both their VE primer and polyester primer. It sands very easily and I usually thin with acetone after catalyzing it. Although they have a special thinner I have not used it. Duratec needs to be thinned as it is very viscous and hard to spray. I have sprayed awlgrip over it with good results. It has a fast cure rate so you cant let it sit like awlgrip primer. I mostly use duratec as the first layer on a new part in a mold. You can roll it on inside the mold. Let it cure and then start laying glass. So instead of gel coat I like duratec so I can then sand the part and spray with paint. It will cover pin holes easily.
strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
|