[flyingfrizzle]

Last night I made a knee to support the transom and bracket. I want to get the bilge area finished out so I can get my top cap back on and seemed together. Left a small area open at the center of the rear for a low point for bilge pump and I also like my drain holes centered not to the side like original. Skimmed some short strand fiber puddy on the knee to smooth it out for the glass wrap. I used 1708 for some of the smaller areas then the roven backed with matt over the main part of the knee. Would of used all 1708 but still got some free roven to use so it has to go somewhere. I also applyed some more tabbing on the stringers just for over kill. They should be 3/8 thick where they meet the transom or more now. Tonight I will go around and tab the knee in better and make sure it is 100 percent covered.