I decided to put an anchor locker door in so I made a mold for the door and the acess panel at the same time. it was easier to cut the template for the flange and make it 1/8" bigger with some luan.
I also made a box for to go over the fill and vent hose. I will drill 2 holes through it for them and mount it down to the floor to keep stuff from falling on top of the tank.
gonna do one more layer of glass on the anchor hatch then pop it off.
I cleaned up the transom with the flush cut bit in the router, I then took out the grinder and cleaned the transom down for some glass I hand sanded the corners and put a radius on the corners to make the glass roll easier.
