Got the bracket back on the boat and marking where to paint the grey bottom paint. Getting measurements for backing plates and mocking up the motor bolt holes so i can drill them at the right height. Hope to go up 4 plus inches for the setback. I thought it was 24" but more like 23" on the mark so I'm thinking a inch per foot like said then add 2 more due to everyone goes up never down. I'm going to run a rev 4 so it can be high with that being a simi-surface type wheel. I will try to make it so i can go up more than down at that point. WhatWhat do you guys think on the plus 4 inches? Play it safe with 3-3 1/2" or go for 4"?
