[Chaser]

The last couple weeks have been pretty busy. Removed the deck, cleaned, and now I am drying everything out and prepping to begin building the sole and support. Going to raise the whole thing about 1/2-1" from where it was.

I found that the factory had sawed out a section of the port stringer to route the fuel fill/vent to the tank. Crazy since there is a channel molded in for that... Maybe they didn't have quite enough hose to reach the tank

I'll try to post more pics as progress continues.

https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing
https://drive.google.com/file/d/0B4Z...ew?usp=sharing