Hard Top Construction
We used 3/4 inch Divinycell foam epoxy/cabosiled together. It wanted to curve a little, so we let it and could eye ball it was close on its own. Not shown are the one hundred screws and fender washers that we glued the overlapping panels together with for 4 hours and then we removed them and put batteries on top.
We then put one layer of 17 oz on the bottom just so we could move it around safely. Then drilled quarter inch holes from the other side down to glass to act as "bolts" which later will be filled with slightly thickened epoxy. This will connect the two outer layers of glass.
Last two show the top, no glass yet, just sitting on t top as dry fit.
|