I'd like to pass along few tid bits on my recent bolster project.
Because of the flare at the bow the backing has to be done with a template first.
Once I cut the backing to size I stapled 3'' pieces of piping along the top edge of the backing, this will allow me to get a smooth exact transition off the gunnel prior to drilling any holes.
I went with the 2'' foam but after making a sample bolster its looked to square imo. I played with dimensions by cutting the corner of the foam with electric knife which worked great. Leaving 3/4'' on the short side and 1 1/2'' on the long side I marked 2 lines for an easy straight cut. Also, 1/2'' over hang on the backing.
Prior to beginning stapling the vinyl to the backing, I stapled 4 staples on one end stapling to the table, this allows me to get a real tight stretch on the vinyl and will eliminate wrinkles at the bow. Stainless 1/2'' staples worked best
I'll post some pics later on.
|