View Single Post
  #9  
Old 06-19-2018, 12:10 PM
Vezo, Part II Vezo, Part II is offline
Senior Member
 
Join Date: Mar 2012
Posts: 1,026
Default

A little tough on a table saw to match angle/beveled edge on top to match the angle of the outer panel, but the factory was spot on for a SeaCraft.

No affiliation: Jeff, is salesman and knows SeaCraft bottoms incessively. Kim is very knowledgeable, answers phones and admin.. Greg runs the shop. All three are Owens, and awesome to work with. Any other questions they can answer. Be prepared. When Jeff gets on the phone he will have answers for you. Write them down in advance because they are always BUSY.

Hope this helps.

Michael.
Reply With Quote