Quote:
Originally Posted by AlabamaRick
Looking for opinions and experiences from CSC'ers who have dealt with the dust that the fiberglass boat repair process creates. I have recently acquired a 72' SF, and looks like I may have to use my attached garage and/or driveway for a while as my work area. I have looked at some of the high dollar options (fein, festool ) and though I am not opposed to going this route,I wanted to see what set ups you guys are using and how effective they are. Ideally I would like my grinder to connect to a vacuum, so any thoughts on this will be greatly appreciated.
|
Got this from Amazon yesterday, my neighbor called it the hootennanny. Theoretically,it is supposed to save time and money by collecting dust/trash in the bucket before entering the vacuum. We shall see, I am going to try it out on my old,soon to be replaced,filter clogging, sux at sucking vac. Fingers crossed... I used a bucket and a lid with a rubber seal,cut and drilled a plywood backing plate for extra strength for the thin plastic. Oops, sorry about the side ways pics
