[No grave but the Seacraft]

I've been working on this project for a couple of months before joining the community so I had a stockpile of photos to upload but this post will bring it up to date. I used two layers of 3/4" 26# Coosa with a layer of 1700 biaxial glass between them for the stringer extension/outboard bracket. I'm using epoxy resin for the entire build so didn't bother with 1708 glass. I will be using the same combination for the transom but will have three layers for the actual motor mount. I will have a longitudinal support "shelf" glassed on the inside of the transom on top of the stringers. The plywood is just for my templates and to use for nesting on the sheets of coosa. Can't afford any waste. I have yet to cut down the freeboard out of fear but maybe in the next few days.