Finished up cutting most of the tabbing to get at the remainder ply in the bottom of the boat. The keel stringer is shot- you can see where it has been screwed into over the years.
It seems like when they installed the I/O 2x6 motor mounts they layered the glass over the mounts, down the hull, over the keel and back up to the opposite mount. I found the glass on the sides of the mounts were delaminating with water in the bilge area- prying it and cutting it back it seems like it works its way forward in the boat. Does anyone have any insight to where this glass should stop? i don't want to pull too much up.
|