shifter

[david76]

ok i need some help here again i was putting new rails on and i had to take my shifter off well i put the new rail on and now i have no forward and reverse. i can put it in gear and manually put it in gear but the shifter will not put it in gear did something break i cant figure it out everything was working fine before. So any input would be appreciated!!!!

[hermco]

Hook up the cables?

[david76]

everything is attached i cant figure it out could something have broke inside?

[hermco]

Is unlikely. Try disconnecting cables from motor and check shift operation. You might have the throttle and shift cables switched.Also make sure the neutral throttle isn't engaged on the control.

[david76]

how do i know if it is neutral? and if it is how do i get it out? Like i said it was working fine before it came off now it dont work. I kinda messed up when i went to pull it off i pulled the three screws out and the bottom plate came off and the cables came out so i put them back in didnt think it was a big deal. and now i have this delima!

[hermco]

Ok. What make of control is it? Maybe I can talk you thru it.