Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #7  
Old 03-14-2006, 01:00 PM
Bay Runner Bay Runner is offline
Member
 
Join Date: Oct 2002
Location: Mechanicsville, VA
Posts: 44
Default Re: Trim tabs + paint ????????

PeterB, Stainless can be drilled with a sharp metal bit! The trick is Slow drill between 400 and 600 rpm and don't use any oil or lube, you will be supprised at how easy stainless will cut. Also if ya'll are using up anodes that quickly there must be an auful lot of electricity leaking into the water from somewhere (your boat or a neighboring boat).
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft