|
|
#11
03-21-2006, 05:31 PM
|
|||
|
|||
Re: Yet Another Transom Job in the Works - ?ions
My new fuel tank should be ready in a couple of days ..
reading back on previous posts there are a variety of methods to coat the new tank - Coal Tar Epoxy POR-15 Paint Line-X Bedliner 2 Part Epoxy Paint My question is can I coat the tank with some of the RAKA epoxy that I have? I was going to clean the tank - rough it up with some 80 grit and roll on the 2 part epoxy. Is this a good or bad idea? The reason for wanting to use the epoxy is because I have it on hand ready to go. My other option is to have it powder coated with a mil spec powder coat but that will cost me about $3/sq ft AND it might take a while to have done. thanks Jack
__________________
"Anything you let a dog do, you're training it to do." - 1977 23' Superfish ST250x Yam 
|
|
|
Threaded Mode